Error Code 8C1
The washer's vibration and motion sensor has detected a data error.
Moderate
Address soon - your appliance may not work properly
Also displayed as: 8C1
What This Means
MEMS PBA fault; Data error in MEMS sensor; Wire connection issue
What actually causes this:
The MEMS vibration sensor has a loose connection or has failed.
First Thing to Check
Unplug the washer for 60 seconds and plug it back in to reset.
Parts Involved
How to Fix
- 1
1. Check the wire connections to the MEMS sensor
- 2
2. Replace the MEMS PBA if necessary
This Error Applies To
Samsung WV60M9900A Series Washers (2024) (2024–present)
Related Error Codes
The incoming water is too hot for the selected gentle cycle.
The washer cannot pump out the water after a wash or rinse cycle.
The washer is not getting enough electrical power to run properly.
The washer is not getting enough water or no water at all.
The washer's WiFi module has lost its connection to the main board.
The washer cannot detect the water level inside the tub.
The washer is getting too much electrical power, which can damage it.
The washer's door lock mechanism is not engaging or disengaging correctly.