Error Code SUD
There are too many soap bubbles in the washer and it is pausing to remove them.
Moderate
Address soon - your appliance may not work properly
Also displayed as: Sud or SUdS
What This Means
Too much detergent used; Non-HE detergent used; Excessive foaming detected during wash cycle
What actually causes this:
Too much detergent was used, or a non-HE (high-efficiency) detergent was used in this front-load washer.
First Thing to Check
Wait for the washer to clear the suds on its own. This usually takes a few extra minutes.
How to Fix
- 1
1. Observe display: 'Sud' or 'SUdS' is shown when too much foam is detected
- 2
2. Wait for '0' to display, indicating foam removal is finished
- 3
3. This is a normal protective operation and the cycle will resume automatically
This Error Applies To
Samsung WV60M9900A Series Washers (2024) (2024–present)
Related Error Codes
The washer's heater got dangerously hot and the machine shut itself off for safety.
The laundry load is not evenly distributed, causing the washer to vibrate too much during spin.
The incoming water is too hot for the selected gentle cycle.
The washer cannot pump out the water after a wash or rinse cycle.
The washer is not getting enough electrical power to run properly.
The washer is not getting enough water or no water at all.
The washer's WiFi module has lost its connection to the main board.
The washer cannot detect the water level inside the tub.