Error Code 4C2
The water coming into your washer is too hot for the selected cycle.
Moderate
Address soon - your appliance may not work properly
Also displayed as: 4C2
What This Means
Cold and warm water supply hoses are wrongly engaged into each other; Temperature of water supplied through the dry valve during a dry cycle is sensed as higher than 70°C; Water temperature is sensed as higher than 50°C in Wool or Lingerie courses
What actually causes this:
The hot and cold water hoses behind the washer are swapped — hot is connected where cold should be and vice versa.
First Thing to Check
Check that the hot and cold water hoses behind the washer are connected to the correct faucets (hot to hot, cold to cold).
Parts Involved
How to Fix
- 1
1. Verify cold and hot water supply hoses are connected to the correct inlets
- 2
2. Check the water temperature being supplied
- 3
3. Verify the thermistor reading
Parts Commonly Needed for This Error
OEM part numbers confirmed by retailers
Other Error Codes for WA52J8700AP
Your washer's vibration sensor board has a fault.
Your washer cannot detect the position of its internal clutch.
Your washer's main computer chip has failed.
Your washer's vibration sensor has detected a data error.
Your washer's water heating element has a specific fault.
Your washer's drying heater has a specific fault.
Your washer's vibration sensor board has failed.
Your washer's motor speed controller has lost connection to the main board.