Error Code DC
Your washer does not detect the lid as properly closed.
Moderate
Address soon - your appliance may not work properly
Also displayed as: DC
What This Means
Switch contact check because of a deformation of the door hook; Door is pulled by force; Occurs in Boil wash because the door is pushed due to a pressure difference from internal temperature changes
What actually causes this:
The lid is not fully shut, or something is keeping it from closing completely, like a piece of laundry caught in the opening.
First Thing to Check
Open and firmly close the lid, making sure nothing is caught in the way.
Parts Involved
How to Fix
- 1
1. Check the Reed SW resistance between terminals — Resistance: Approx. 0.2 ohms (Checking Part: White-Green Wire)
- 2
2. Since 120V power is connected, check if door switch is defective
- 3
3. As this check occurs because the door is opened, close the door
Other Error Codes for WA52J8700AP
Your washer's vibration sensor board has a fault.
Your washer cannot detect the position of its internal clutch.
Your washer's main computer chip has failed.
Your washer's vibration sensor has detected a data error.
Your washer's water heating element has a specific fault.
Your washer's drying heater has a specific fault.
Your washer's vibration sensor board has failed.
Your washer's motor speed controller has lost connection to the main board.