Error Code 8C2
The washer's vibration and motion sensor hardware has failed.
Moderate
Address soon - your appliance may not work properly
Also displayed as: 8C2
What This Means
MEMS PBA hardware fault; Wire connection issue
What actually causes this:
The MEMS vibration sensor hardware has failed.
First Thing to Check
Unplug the washer for 60 seconds and plug it back in to reset.
Parts Involved
How to Fix
- 1
1. Check the wire connections to the MEMS sensor
- 2
2. Replace the MEMS PBA if necessary
Other Error Codes for WV60A9900AV
The washer's heater got dangerously hot and the machine shut itself off for safety.
The laundry load is not evenly distributed, causing the washer to vibrate too much during spin.
The incoming water is too hot for the selected gentle cycle.
The washer cannot pump out the water after a wash or rinse cycle.
The washer is not getting enough electrical power to run properly.
The washer is not getting enough water or no water at all.
The washer's WiFi module has lost its connection to the main board.
The washer cannot detect the water level inside the tub.