Error Code d**
FlowSense duct blockage indicator – four bars shown during drying cycle or 'dso' shown after drying; significant ductwork restriction detected
Moderate
Address soon - your appliance may not work properly
Also displayed as: d**
How to Fix
- 1
Inspect and clean lint filter.
- 2
Check ductwork for excessive length, too many elbows, kinks, or crushes.
- 3
Clean ductwork for lint buildup.
- 4
Check vent hood at the exterior for blockage.
- 5
FLOW SENSE indicator will remain on for two hours after cycle end if restriction was sensed. Opening door or pressing POWER clears the display.
- 6
Dryer can continue to be used but drying times will be longer until ductwork is corrected.
Other Error Codes for DLE8400VE
Temperature sensor (thermistor) failure – thermistor shorted
FlowSense duct blockage – ductwork is approximately 95% blocked (displayed for 2 hours after cycle ends)
Temperature sensor (thermistor) failure – thermistor open circuit
Humidity sensor (electrode/moisture sensor) failure
Power supply error – electric dryer power cord not connected correctly or house power supply is incorrect / insufficient voltage (below 240V on L1-L2 leg reaching PCB)
FlowSense duct blockage – ductwork is approximately 90% blocked
No power / power cord not connected correctly (electric dryer only)
Gas supply failure – gas not being supplied to the dryer (gas model only)