Error Code nP
No power detected — power supply issue
Moderate
Address soon - your appliance may not work properly
Also displayed as: nP
How to Fix
- 1
Verify dryer is plugged in completely.
- 2
Check outlet voltage (110-125V AC for gas; 240V for electric).
- 3
Reset circuit breaker or replace fuse.
- 4
Inspect power cord for damage.
- 5
Verify terminal block connections are tight.
Other Error Codes for DLGY1702BE
Humidity/moisture sensor failure
Ductwork approximately 95% blocked — Flow Sense detection — severe restriction
Power failure — same causes as PS code
Flow Sense shows 80% duct restriction after a drying cycle — ductwork needs attention
Steam pump error — pump AD value below threshold during diagnostic test mode
Installation test mode successfully activated — Flow Sense installation test
Temperature sensor (thermistor) failure — short circuit or secondary thermistor fault
Power supply error — electric dryer power cord not connected correctly, or house power supply is incorrect