Error Code dS
Your washer thinks the door is not closing properly.
Moderate
Address soon - your appliance may not work properly
Also displayed as: dS
What This Means
Switch contact error because of deformation of the door hook; Door was pulled by force
What actually causes this:
The door was forced open during a cycle, or the door latch is slightly bent or worn.
First Thing to Check
Open the door fully and close it again firmly until you hear it click.
Parts Involved
How to Fix
- 1
1. Check the door switch
- 2
2. Check resistance of pins 1 and 3 — must be approximately 125Ω
- 3
3. If a dS error occurs, check whether it is detected that the door is open — if so, close the door
- 4
4. Check the door switch — replace if faulty
- 5
5. Check the main PBA door sensing — replace if faulty
This Error Applies To
Samsung WF42H5000AW Series Washers (2014) (2014–present)
Related Error Codes
Your washer's motor is struggling and cannot run properly.
Your washer cannot detect the water level properly.
Your washer's motor cannot spin the drum.
Your washer detected a problem with its motor sensor.
Your washer cannot pump the water out.
The control boards inside your washer are not communicating.
Your washer is not getting enough water.
Your washer is not getting the right amount of electrical power.