Error Code SF
Your washer has an internal system error.
Critical
Stop using immediately - risk of damage or safety issue
Also displayed as: SF
What This Means
EEPROM detected error; PBA problem; System error
What actually causes this:
The main control board has encountered a software or hardware fault.
First Thing to Check
Unplug the washer for 60 seconds, then plug it back in and try again.
Parts Involved
How to Fix
- 1
1. Power cycle the washer (unplug for 60 seconds)
- 2
2. Check main PBA
- 3
3. Replace PBA if fault persists
This Error Applies To
Samsung WF42H5000AW Series Washers (2014) (2014–present)
Related Error Codes
Your washer's motor is struggling and cannot run properly.
Your washer cannot detect the water level properly.
Your washer's motor cannot spin the drum.
Your washer detected a problem with its motor sensor.
Your washer cannot pump the water out.
The control boards inside your washer are not communicating.
Your washer is not getting enough water.
Your washer is not getting the right amount of electrical power.