Error Code tE
Your washer cannot read the water temperature properly.
Moderate
Address soon - your appliance may not work properly
Also displayed as: tE
What This Means
Washing heater in tub has a contact error or temperature sensor fault; Connector is connected incorrectly or is disconnected; Frozen water causes water level sensor to operate without water, heater overheats to 100-150°C; Washing temperature sensor fault; Dry temperature sensor fault; Faulty and incorrect connections of dry heater temperature sensor; Duct condensing temperature sensor fault; Main PCB fault; Freezing in the winter season
What actually causes this:
A temperature sensor connector has come loose or the sensor itself has failed.
First Thing to Check
Unplug the washer for 60 seconds, then plug it back in and try again.
Parts Involved
How to Fix
- 1
1. Check the connections for the washing heater temperature sensor connector
- 2
2. If the washing heater temperature sensor has a functional error, replace it
- 3
3. Check the connections for the dry heater temperature sensor connector
- 4
4. If the dry heater temperature sensor has a functional error, replace it
- 5
5. Check the connections for the duct condensing temperature sensor connector
- 6
6. If the duct condensing temperature sensor has a functional error, replace it
- 7
7. Check for Main PCB fault
- 8
8. Check for freezing in winter season
This Error Applies To
Samsung WF42H5000AW Series Washers (2014) (2014–present)
Related Error Codes
Your washer's motor is struggling and cannot run properly.
Your washer cannot detect the water level properly.
Your washer's motor cannot spin the drum.
Your washer detected a problem with its motor sensor.
Your washer cannot pump the water out.
The control boards inside your washer are not communicating.
Your washer is not getting enough water.
Your washer is not getting the right amount of electrical power.